I'm in the process of making McCall's 6329 for DD. She's in need of a few work clothes. So I decided to help her beef up the work wardrobe. I'll use M6329 for two jackets that I'm planning to make for her over the next several weeks.
Part of the process is to make sure the fit is good. So I started with tissue fitting the pattern.
First I determined the correct size to use for her by measuring her high bust measurement. If it is the exact number or a number between two sizes as indicated on the pattern (bust measurement), I selected the next smaller size. Example, my DD measured 33 inches. I used size 10.
Next I prepared the pattern for fitting. I marked the 5/8" allowance, applied tape, and clipped where necessary for all seams that would be pinned. Then pinned the pieces together to fit.
I started the fit process from the back. Then worked my way to the front.
DD's center back seam comes about 3/4" pass the center of her back. The shoulder look fine.
Second observation, there is room for shoulder pads.
Note how the front wings out to the side. There isn't enough room across the bust area.
The center front is about 1" away from DD's center front. So I need to do a FBA.
I can pinch more the an inch on the upper arm of the sleeve. Not too bad. (Special note: It's pulled slightly higher than it should be. We were having some technical difficulty with photography and fitting at the same time. I hope you get the idea.)
Parting Video from Sandra Betzina - Fall is on its way. And if you are like me, you are planning to make pants with lining. For years I've practiced sewing my lining a tad bit larger than the garment. This video clip speaks to that technique. So here is the preview "Learn to Sew Linings A To Z with Sandra Betzina."
